Packet data access points
Select
Menu
>
Tools
>
Settings
and
Connection
>
Destinations
>
Access point
, and follow the
instructions on the display. Or, open one of the access
point groups, select an access point marked with
,
and select
Edit
.
Use the instructions provided by your service provider
to edit the following:
●
Access point name
— The access point name is
provided by your service provider.
●
User name
— The user name may be needed to
make a data connection, and is usually provided by
your service provider.
●
Prompt password
— If you want to set the device
to ask for a password every time you log in to a
server, or if you do not want to save your password
in the device, select
Yes
.
●
Password
— A password may be needed to make
a data connection and is usually provided by your
service provider.
●
Authentication
— Select
Secure
to always send
your password encrypted or
Normal
to send your
password encrypted when possible.
●
Homepage
— Depending on the access point type
you are setting up, enter the web address or the
address of the multimedia message centre.
●
Use access point
— Select
After confirmation
to
set the device to ask for confirmation before the
connection using this access point is created, or
Automatically
to set the device to connect to the
destination using this access point automatically.
Select
Options
>
Advanced settings
and from the
following:
146
Se
ttings
●
Network type
— Select the internet protocol type
to transfer data to and from your device. The other
settings depend on the selected network type.
●
Phone IP address
(for IPv4 only) — Enter the IP
address of your device.
●
DNS addresses
— Enter the IP addresses of the
primary and secondary DNS servers, if required by
your service provider. To obtain these addresses,
contact your internet service provider.
●
Proxy server address
— Enter the address of the
proxy server.
●
Proxy port number
— Enter the port number of
the proxy server.