Colour and lighting settings
In the active toolbar, select from the following:
●
Flash mode
( ) (image only) — Select the desired
flash mode.
●
Colour tone
( ) — Select a colour effect.
●
Switch video light on
or
Switch video light off
— Switch the video light on or off (video mode
only).
●
White balance
( ) — Select the current lighting
condition. This allows the camera to reproduce
colours more accurately.
●
Exposure compensation
( ) (image only) — If you
are shooting a dark subject against a very light
background, such as snow, adjust the exposure to
+1 or +2 to compensate for the background
brightness. For light subjects against a dark
background, use -1 or -2.
●
Sharpness
( ) (image only) — Adjust the
sharpness of the image.
40
Ca
mera
●
Contrast
( ) (image only) — Adjust the difference
between the lightest and darkest parts of the image.
●
Light sensitivity
( ) (image only) — Increase the
light sensitivity in low light conditions to avoid too
dark images.
The screen display changes to match the settings you
make.
The available settings vary depending on the selected
camera.
The setup settings are shooting-mode specific.
Switching between the modes does not reset the
defined settings.
The setup settings return to the default settings when
you close the camera.
If you select a new scene, the colour and lighting
settings are replaced by the selected scene. You can
change the setup settings after selecting a scene if
needed.